Z3SMC1 ... Z3SMC200 (3 W)
Z3SMC1 ... Z3SMC200 (3 W)
Surface Mount Silicon-Zener Diodes (non-planar tec hnolo gy)
Flächendiffundierte Si-Zener-Dioden für die Oberflächenmontage
Version 2006-04-24
Dimensions - Maße [mm]
Maximum power dissipation
Maximale Verlustleistung
3 W
Nominal Z-voltage
Nominale Z-Spannung
1...200 V
Plastic case
Kunststoffgehäuse
~ SMC
~ DO-214AB
Weight approx. – Gewicht ca. 0.21 g
Plastic material has UL classification 94V-0
Gehäusematerial UL94V-0 klassifiziert
Standard packaging taped and reeled
Standard Lieferform gegurtet auf Rolle
Standard Zener voltage tolerance is graded to the international E 24 (~ ±5%) standard.
Other voltage tolerances and higher Zener voltages on request.
Die Toleranz der Zener-Spannung ist in der Standard-Ausführung gestuft nach der internationalen
Reihe E 24 (~ ±5%). Andere Toleranzen oder höhere Arbeitsspannungen auf Anfrage.
Maximum ratings and Characteristics Grenz- und Kennwerte
Z3SMC-series
Power dissipation – Verlustleistung T
A
= 50°C P
tot
3 W
1
)
Non repetitive peak power dissipation, t < 10 ms
Einmalige Impuls-Verlustleistung, t < 10 ms
T
A
= 25°C P
ZSM
60 W
Operating junction temperature – Sperrschichttemperatur
Storage temperature – Lagerungstemperatur
T
j
T
S
-50...+150°C
-50...+175°C
Thermal resistance junction to ambient air
Wärmewiderstand Sperrschicht – umgebende Luft
R
thA
< 33 K/W
1
)
Thermal resistance junction to terminal
Wärmewiderstand Sperrschicht – Anschluss
R
thT
< 10 K/W
Zener voltages see table on next page – Zener-Spannungen siehe Tabelle auf der nächsten Seite
23
1 Mounted on P.C. board with 50 mm
2
copper pads at each terminal
Montage auf Leiterplatte mit 50 mm
2
Kupferbelag (Lötpad) an jedem Anschluss
2 Tested with pulses – Gemessen mit Impulsen
3 The Z3SMC1 is a diode operated in forward. Hence, the index of all parameters should be “F” instead of “Z”.
The cathode, indicated by a white band, has to be connected to the negative pole.
Die Z3SMC1 ist eine in Durchlass betriebene Si-Diode. Daher ist bei allen Kenn- und Grenzwerten der Index
“F” anstatt “Z” zu setzten. Die mit weißem Balken gekennzeichnete Kathode ist mit dem Minuspol zu verbinden.
© Diotec Semiconductor AG http://www.diotec.com/
1
0.15
Type
Typ
1.2
3
5.8
±0.2
2.2
±0.2
2.1
±0.1
7.9
±0.2
7.
±0.2