• 当前位置:
  • 首页
  • >
  • PDF资料
  • >
  • WS064J0SBFW00 PDF文件及第15页内容在线浏览

WS064J0SBFW00

WS064J0SBFW00首页预览图
型号: WS064J0SBFW00
PDF文件:
  • WS064J0SBFW00 PDF文件
  • WS064J0SBFW00 PDF在线浏览
功能描述: 128/64 Megabit (8/4 M x 16-Bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst Mode Flash Memory
PDF文件大小: 2245.3 Kbytes
PDF页数: 共97页
制造商: SPANSION[SPANSION]
制造商LOGO: SPANSION[SPANSION] LOGO
制造商网址: http://www.spansion.com
捡单宝WS064J0SBFW00
PDF页面索引
120%
May 11, 2006 S29WS-J_00_A6 S29WS128J/064J 15
Data Sheet
Prior to entering burst mode, the system should determine how many wait states are desired for
the initial word (t
IACC
) of each burst access, what mode of burst operation is desired, which edge
of the clock will be the active clock edge, and how the RDY signal will transition with valid data.
The system would then write the configuration register command sequence. See
“Set Configura-
tion Register Command Sequence” section on page 47 and “Command Definitions” section on
page 46 for further details.
Once the system has written the “Set Configuration Register” command sequence, the device is
enabled for synchronous reads only.
The initial word is output t
IACC
after the active edge of the first CLK cycle. Subsequent words are
output t
BACC
after the active edge of each successive clock cycle, which automatically increments
the internal address counter. Note that the device has a fixed internal address boundary that oc
-
curs every 64 words, starting at address 00003Fh.
During the time the device is outputting data at this fixed internal address boundary (address
00003Fh, 00007Fh, 0000BFh, etc.), a two cycle latency (WS128J/064J model numbers 00 and
01) or a three cycle latency (WS128J model numbers 10 and 11) occurs before data appears for
the next address (address 000040h, 000080h, 0000C0h, etc.).
Additionally, when the device is read from an odd address, one wait state is inserted when the
address pointer crosses the first boundary that occurs every 16 words. For instance, if the device
is read from 000011h, 000013h, … ,00001Fh (odd), one wait state is inserted before the data of
000020h is output. This wait is inserted only at the boundary of the first 16 words. Then, if the
device is read from the odd address within the last 16 words of 64 word boundary (address
000031h,000033h, … , 00003Fh), a three-cycle latency occurs before data appears for the next
address (address 000040h). During the boundary crossing condition, the system must assert an
additional wait state for WS128J model numbers 10 and 11.
The RDY output indicates this condition to the system by pulsing deactive (low). See Figure 35,
“Latency with Boundary Crossing,” on page 89.
The device will continue to output sequential burst data, wrapping around to address 000000h
after it reaches the highest addressable memory location, until the system drives CE# high, RE
-
SET# low, or AVD# low in conjunction with a new address. See Tab le 1, “Device Bus Operations,
on page 14.
If the host system crosses the bank boundary while reading in burst mode, and the device is not
programming or erasing, a two-cycle latency will occur as described above in the subsequent
bank. If the host system crosses the bank boundary while the device is programming or erasing,
the device will provide read status information. The clock will be ignored. After the host has com
-
pleted status reads, or the device has completed the program or erase operation, the host can
restart a burst operation using a new address and AVD# pulse.
8-, 16-, and 32-Word Linear Burst with Wrap Around
The remaining three burst read modes are of the linear wrap around design, in which a fixed num-
ber of words are read from consecutive addresses. In each of these modes, the burst addresses
read are determined by the group within which the starting address falls. The groups are sized
according to the number of words read in a single burst sequence for a given mode (see
Ta bl e 2.)
Ta b l e 2. Burst Address Groups
Mode Group Size
Group Address Ranges
8-word 8 words 0-7h, 8-Fh, 10-17h,...
16-word 16 words 0-Fh, 10-1Fh, 20-2Fh,...
32-word 32 words 00-1Fh, 20-3Fh, 40-5Fh,...
购买、咨询产品请填写询价信息:(3分钟左右您将得到回复)
询价型号*数量*批号封装品牌其它要求
删除
删除
删除
删除
删除
增加行数
  •  公司名:
  • *联系人:
  • *邮箱:
  • *电话:
  •  QQ:
  •  微信:

  • 关注官方微信

  • 联系我们
  • 电话:13714778017
  • 周一至周六:9:00-:18:00
  • 在线客服:

天天IC网由深圳市四方好讯科技有限公司独家运营

天天IC网 ( www.ttic.cc ) 版权所有©2014-2023 粤ICP备15059004号

因腾讯功能限制,可能无法唤起QQ临时会话,(点此复制QQ,添加好友),建议您使用TT在线询价。

继续唤起QQ 打开TT询价