Register 10: PWM Fault Condition Value (PWMFAULTVAL), offset 0x024
This register specifies the output value driven on the PWMnsignals during a fault condition if enabled
by the corresponding bit in the PWMFAULT register. Note that if the corresponding bit in the
PWMINVERT register is set, the output value is driven to the logical NOT of the bit value in this
register.
PWM Fault Condition Value (PWMFAULTVAL)
PWM0 base: 0x4002.8000
Offset 0x024
Type R/W, reset 0x0000.0000
16171819202122232425262728293031
reserved
ROROROROROROROROROROROROROROROROType
0000000000000000Reset
0123456789101112131415
PWM0PWM1PWM2PWM3PWM4PWM5reserved
R/WR/WR/WR/WR/WR/WROROROROROROROROROROType
0000000000000000Reset
DescriptionResetTypeNameBit/Field
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
0x0000.00ROreserved31:6
PWM5 Fault Value
DescriptionValue
The PWM5 output signal is driven High during fault conditions if
the FAULT5 bit in the PWMFAULT register is set.
1
The PWM5 output signal is driven Low during fault conditions if
the FAULT5 bit in the PWMFAULT register is set.
0
0R/WPWM55
PWM4 Fault Value
DescriptionValue
The PWM4 output signal is driven High during fault conditions if
the FAULT4 bit in the PWMFAULT register is set.
1
The PWM4 output signal is driven Low during fault conditions if
the FAULT4 bit in the PWMFAULT register is set.
0
0R/WPWM44
PWM3 Fault Value
DescriptionValue
The PWM3 output signal is driven High during fault conditions if
the FAULT3 bit in the PWMFAULT register is set.
1
The PWM3 output signal is driven Low during fault conditions if
the FAULT3 bit in the PWMFAULT register is set.
0
0R/WPWM33
July 24, 2012858
Texas Instruments-Production Data
Pulse Width Modulator (PWM)
OBSOLETE: TI has discontinued production of this device.
