sequencer units with the same priority do not provide consistent results, so software must ensure
that all active sample sequencer units have a unique priority value.
12.3.2.4 Sampling Events
Sample triggering for each sample sequencer is defined in the ADC Event Multiplexer Select
(ADCEMUX) register. Trigger sources include processor (default), analog comparators, an external
signal on GPIO PB4, a GP Timer, a PWM generator, and continuous sampling. The processor
triggers sampling by setting the SSx bits in the ADC Processor Sample Sequence Initiate
(ADCPSSI) register.
Care must be taken when using the continuous sampling trigger. If a sequencer's priority is too high,
it is possible to starve other lower priority sequencers. Generally, a sample sequencer using
continuous sampling should be set to the lowest priority. Continuous sampling can be used with a
digital comparator to cause an interrupt when a particular voltage is seen on an input.
12.3.2.5 Sample Phase Control
The trigger source for ADC0 and ADC1 may be independent or the two ADC modules may operate
from the same trigger source and operate on the same or different inputs. If the converters are
running at the same sample rate, they may be configured to start the conversions coincidentally or
with one of 15 different discrete phases relative to each other. The sample time can be delayed
from the standard sampling time in 22.5° increments up to 337.5º using the ADC Sample Phase
Control (ADCSPC) register. Figure 12-3 on page 539 shows an example of various phase
relationships at a 1 Msps rate.
Figure 12-3. ADC Sample Phases
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
ADC Sample Clock
PHASE 0x0 (0.0°)
PHASE 0x1 (22.5°)
PHASE 0xE (315.0°)
PHASE 0xF (337.5°)
.
.
.
.
.
.
.
.
.
.
.
.
19
This feature can be used to double the sampling rate of an input. Both ADC module 0 and ADC
module 1 can be programmed to sample the same input. ADC module 0 could sample at the standard
position (the PHASEfield in the ADCSPC register is 0x0). ADC module 1 can be configured to sample
at 180 (PHASE = 0x8). The two modules can be be synchronized using the GSYNC and SYNCWAIT
bits in the ADC Processor Sample Sequence Initiate (ADCPSSI) register. Software could then
combine the results from the two modules to create a sample rate of two million samples/second
at 16 MHz as shown in Figure 12-4 on page 540.
539July 24, 2012
Texas Instruments-Production Data
Stellaris
®
LM3S6G65 Microcontroller
OBSOLETE: TI has discontinued production of this device.
