SATA-Disk Module 4
APSDMxxxx15XX-PXX
1
© 2013 Apacer Technology Inc. Rev. 1.4
Features:
Standard Serial ATA 2.6 (Gen. 2)
– Serial ATA 2.6 (Gen. 2)
– SATA II, 3.0 Gbps
– ATA-compatible command set
Capacities
– 2, 4, 8, 16, 32, 64 GB
Performance*
– Burst read/write: 300 MB/sec
– Sustained read: up to 165 MB/sec
– Sustained write: up to 150 MB/sec
Intelligent endurance design
– Built-in hardware ECC, enabling up to
16/24 bit correction per 1K bytes
– Wear leveling
– Flash bad-block management
– S.M.A.R.T.
– Power Failure Management
– ATA Secure Erase
– TRIM
NAND Flash Type: SLC
Write Protect switch (optional)
– Write Protect function enabled by hardware
DIP switch
Temperature ranges
– Operation: 0°C to 70°C (32 ~ 158°F)
– Extended: -40 ~ +85°C (-40° ~ 185°F)
– Storage: -40°C to 100°C (-40° ~ 212°F)
Supply voltage
– 5.0 V 5%
Power consumption (typical)*
– Active mode: 333 mA@5.0 V
– Idle mode: 95 mA@5.0 V
Connector type
– 7-pin SATA signal connector
– 15-pin SATA power connector
Form factor
– SATA Disk Module (44 x 30 x 1.6, unit: mm)
Shock & Vibration**
– Shock: 1500G
– Vibration: 15G
MTBF: >2,000,000 hours
RoHS compliant
*Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations
or platform settings. The term idle refers to the standby state of the device.
**Non-operating