Datasheet Information
5-10 Revision 4
Advance 1.0
(continued)
In Table 2-47 • ADC Characteristics in Direct Input Mode, the commercial conditions
were updated and note 2 is new.
2-121
The V
CC33ACAP
signal name was changed to "XTAL1 Crystal Oscillator Circuit
Input".
2-228
Table 2-48 • Uncalibrated Analog Channel Accuracy* is new. 2-123
Table 2-49 • Calibrated Analog Channel Accuracy
1,2,3
is new. 2-124
Table 2-50 • Analog Channel Accuracy: Monitoring Standard Positive Voltages is
new.
2-125
In Table 2-57 • Voltage Polarity Control Truth Table—AV (x = 0), AC (x = 1), and AT
(x = 3)*, the following I/O Bank names were changed:
Hot-Swap changed to Standard
LVDS changed to Advanced
2-131
In Table 2-58 • Prescaler Op Amp Power-Down Truth Table—AV (x = 0), AC (x = 1),
and AT (x = 3), the following I/O Bank names were changed:
Hot-Swap changed to Standard
LVDS changed to Advanced
2-132
In the title of Table 2-64 • I/O Standards Supported by Bank Type, LVDS I/O was
changed to Advanced I/O.
2-134
The title was changed from "Fusion Standard, LVDS, and Standard plus Hot-Swap
I/O" to Table 2-68 • Fusion Standard and Advanced I/O Features. In addition, the
table headings were all updated. The heading used to be Standard and LVDS I/O
and was changed to Advanced I/O. Standard Hot-Swap was changed to just
Standard.
2-136
This sentence was deleted from the "Slew Rate Control and Drive Strength" section:
The Standard hot-swap I/Os do not support slew rate control. In addition, these
references were changed:
• From: Fusion hot-swap I/O (Table 2-69 on page 2-122) To: Fusion Standard I/O
• From: Fusion LVDS I/O (Table 2-70 on page 2-122) To: Fusion Advanced I/O
2-152
The "Cold-Sparing Support" section was significantly updated. 2-143
In the title of Table 2-75 • Fusion Standard I/O Standards—OUT_DRIVE Settings,
Hot-Swap was changed to Standard.
2-153
In the title of Table 2-76 • Fusion Advanced I/O Standards—SLEW and OUT_DRIVE
Settings, LVDS was changed to Advanced.
2-153
In the title of Table 2-81 • Fusion Standard and Advanced I/O Attributes vs. I/O
Standard Applications, LVDS was changed to Advanced.
2-157
In Figure 2-111 • Naming Conventions of Fusion Devices with Three Digital I/O
Banks and Figure 2-112 • Naming Conventions of Fusion Devices with Four I/O
Banks the following names were changed:
Hot-Swap changed to Standard
LVDS changed to Advanced
2-160
The Figure 2-113 • Timing Model was updated. 2-161
In the notes for Table 2-86 • Summary of Maximum and Minimum DC Input Levels
Applicable to Commercial and Industrial Conditions, T
J
was changed to T
A
.
2-166
Revision Changes Page