ProASIC3 Flash Family FPGAs
Revision 13 2-89
Clock Conditioning Circuits
CCC Electrical Specifications
Timing Characteristics
Table 2-115 • ProASIC3 CCC/PLL Specification
Parameter Minimum Typical Maximum Units
Clock Conditioning Circuitry Input Frequency f
IN_CCC
1.5 350 MHz
Clock Conditioning Circuitry Output Frequency f
OUT_CCC
0.75 350 MHz
Serial Clock (SCLK) for Dynamic PLL
1
125 MHz
Delay Increments in Programmable Delay Blocks
2, 3
200
4
ps
Number of Programmable Values in Each Programmable
Delay Block
32
Input Period Jitter 1.5 ns
CCC Output Peak-to-Peak Period Jitter F
CCC_OUT
Max Peak-to-Peak Period Jitter
1 Global
Network
Used
3 Global
Networks
Used
0.75 MHz to 24 MHz 0.50% 0.70%
24 MHz to 100 MHz 1.00% 1.20%
100 MHz to 250 MHz 1.75% 2.00%
250 MHz to 350 MHz 2.50% 5.60%
Acquisition Time
(A3P250 and A3P1000 only) LockControl = 0 300 µs
LockControl = 1 300 µs
(all other dies) LockControl = 0 300 µs
LockControl = 1 6.0 ms
Tracking Jitter
5
(A3P250 and A3P1000 only) LockControl = 0 1.6 ns
LockControl = 1 1.6 ns
(all other dies) LockControl = 0 1.6 ns
LockControl = 1 0.8 ns
Output Duty Cycle 48.5 51.5 %
Delay Range in Block: Programmable Delay 1
2, 3
0.6 5.56 ns
Delay Range in Block: Programmable Delay 2
2, 3
0.225 5.56 ns
Delay Range in Block: Fixed Delay
2, 3
2.2 ns
Notes:
1. Maximum value obtained for a –2 speed-grade device in worst-case commercial conditions. For specific junction
temperature and voltage supply levels, refer to Table 2-6 on page 2-6 for derating values.
2. This delay is a function of voltage and temperature. See Table 2-6 on page 2-6 for deratings.
3. T
J
= 25°C, VCC = 1.5 V
4. When the CCC/PLL core is generated by Microsemi core generator software, not all delay values of the specified delay
increments are available. Refer to the Libero SoC Online Help for more information.
5. Tracking jitter is defined as the variation in clock edge position of PLL outputs with reference to the PLL input clock
edge. Tracking jitter does not measure the variation in PLL output period, which is covered by the period jitter
parameter.
6. The A3P030 device does not contain a PLL.