SmartFusion Customizable System-on-Chip (cSoC)
Revision 10 6-13
Datasheet Categories
Categories
In order to provide the latest information to designers, some datasheet parameters are published before
data has been fully characterized from silicon devices. The data provided for a given device, as
highlighted in the "SmartFusion cSoC Device Status" table on page III, is designated as either "Product
Brief," "Advance," "Preliminary," or "Production." The definitions of these categories are as follows:
Product Brief
The product brief is a summarized version of a datasheet (advance or production) and contains general
product information. This document gives an overview of specific device and family information.
Advance
This version contains initial estimated information based on simulation, other products, devices, or speed
grades. This information can be used as estimates, but not for production. This label only applies to the
DC and Switching Characteristics chapter of the datasheet and will only be used when the data has not
been fully characterized.
Preliminary
The datasheet contains information based on simulation and/or initial characterization. The information is
believed to be correct, but changes are possible.
Production
This version contains information that is considered to be final.
Export Administration Regulations (EAR)
The products described in this document are subject to the Export Administration Regulations (EAR).
They could require an approved export license prior to export from the United States. An export includes
release of product or disclosure of technology to a foreign national inside or outside the United States.
Microsemi SoC Products Group Safety Critical, Life Support,
and High-Reliability Applications Policy
The SoC Products Group products described in this advance status document may not have completed
the SoC Products Group’s qualification process. Products may be amended or enhanced during the
product introduction and qualification process, resulting in changes in device functionality or
performance. It is the responsibility of each customer to ensure the fitness of any product (but especially
a new product) for a particular purpose, including appropriateness for safety-critical, life-support, and
other high-reliability applications. Consult the SoC Products Group’s Terms and Conditions for specific
liability exclusions relating to life-support applications. A reliability report covering all of the SoC Products
Group’s products is available on the SoC Products Group website at
http://www.microsemi.com/soc/documents/ORT_Report.pdf. Microsemi SoC Products Group also offers
a variety of enhanced qualification and lot acceptance screening procedures. Contact your local SoC
Products Group sales office for additional reliability information.