DATASHEET | JULY 2012
FIBER OPTICS
| REV 2012.07
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
Optical Characteristics
Property Units Models Comments
Performance (note 1-8) 6000-J01 6000-J02
Specified Link Length L (km) 25 25
Channel Plan NTSC 80-Ch PAL 60-Ch
With 36 QPSK carriers from 950 to
2800 MHz
Optical Output Power Po (dBm) 8.5/8.5 8.5/8.5 Min. 10 dBm version avail. See Chart
Noise Bandwidth BW (MHz) 4 5
SBS Suppression (dBm) 15.0 15.0 Min.
CATV Carrier to Noise Ratio CNR (dB) 51.0 51.0 Min.
CATV Composite Second Order CSO (dBc) -65 -65 Max. Port 1
CATV Composite Triple Beat CTB (dBc) -65 -65
Max. @ +25C
CATV Composite Triple Beat CTB (dBc) -64 -64 Max. @ 0
o
C to 50
o
C
SAT-IF Carrier to Noise Ratio CNR (dB) 27 27 Min.
SAT-IF Intermodulation Products (dBc) -35 -35 Max. Port 1
SAT-IF Spurious Products (dBc) -38 -38 Max.
Notes:
1. Unless stated otherwise all specifications apply over full temperature range with no digital loading.
2. Unless stated otherwise specifications apply for nominal RF input level as defined below, after a 30 minute stabilization
period.
3. Specifications separated by a slash are port1 / port 2.
4. Units are tested per the Test / Link Configuration Table
5. Noise figure for the EDFA = 4.5 ~ 5.5 dB
6. Corning SMF-28 single mode fiber
7. Receiver responsivity is 0.95 mA/mW, Equivalent noise current is 7 pA/(Hz)1/2
8. With 36 QPSK modulated SAT-IF signals between 950 … 2800 MHz. 27 MHz IF bandwidth
Test/Link Configuration
Property EDFA Link Received Power
2
J-Type 14 dBm 25 Km 0.0 dBm at the receiver
J-T
pe Medallion 6000 1550 nm
Externally Modulated Transmitter