• 当前位置:
  • 首页
  • >
  • PDF资料
  • >
  • SA2002P PDF文件及第1页内容在线浏览

SA2002P

SA2002P首页预览图
型号: SA2002P
PDF文件:
  • SA2002P PDF文件
  • SA2002P PDF在线浏览
功能描述: Programmable Single Phase Kilowatt-hour Energy IC for Mechanical Counter Application
PDF文件大小: 127.27 Kbytes
PDF页数: 共14页
制造商: SAMES[Sames]
制造商LOGO: SAMES[Sames] LOGO
制造商网址: http://www.sames.co.za
捡单宝SA2002P
PDF页面索引
120%
FEATURES
+
+
+
+
+
+
+
Provides a single chip solution for energy meters with a
mechanical display
No external crystal or resonator required
Precision on chip oscillator (<60ppm/°C drift)
Direct stepper motor/impulse counter drive
Calibration and setup stored on external EEPROM - no
trimpots required
Flexible programmable features
Unidirectional and bi-directional power and energy
measurement
sames
Programmable Single Phase Kilowatt-hour
Energy IC for Mechanical Counter
Application
SA2002P
1/14
SPEC-0087 (REV. 5)
05-09-02
+
+
+
+
+
+
+
+
Can measure AC or DC energy.
Meets the IEC 61036 Specification for Class 1 AC Watt
hour meters
Less than 1% error over a dynamic range of 1:1000
Protected against ESD
Total power consumption rating below 30mW
Adaptable to different types of sensors
Operates over a wide temperature range
Precision voltage reference on-chip (<100ppm/°C drift)
DESCRIPTION
The SAMES SA2002P provides a single chip solution for
single phase mechanical counter based energy meters. A
precision oscillator, that replaces an external crystal is
integrated on chip.
The SA2002P does not require any external trim-pots. All
required calibration and configuration data is read from a small
external EEPROM. The data stored in the EEPROM consists
of direction mode (unidirectional or bidirectional), calibration
data, meter rated conditions, LED pulse rate, counter pulse
width, counter resolution and creep threshold. A
programmable high frequency pulse output is available on the
LED output for meter calibration purposes.
The SA2002P single phase kWh metering integrated circuit
generates a pulse rate with a frequency proportional to the
power consumption. The SA2002P performs active power
measurement and takes the power factor into account.
The SA2002P integrated circuit is available in 16 pin dual-in-
line plastic (PDIP16) and small outline (SOIC16) package
types.
Figure 1: Block diagram
IIP
IIN
IVP
GND
VREF
DR-01607
POWER
TO
PULSE RATE
DIRO
V
DD
V
SS
POWER
INTEGRATOR
ANALOG
SIGNAL
PROCESSING
TIMINGOSC
VOLTAGE
REF.
IIC BUS
INTERFACE
LED
MOP
MON
RLOAD
TEST SCL SDA
FMO
购买、咨询产品请填写询价信息:(3分钟左右您将得到回复)
询价型号*数量*批号封装品牌其它要求
删除
删除
删除
删除
删除
增加行数
  •  公司名:
  • *联系人:
  • *邮箱:
  • *电话:
  •  QQ:
  •  微信:

  • 关注官方微信

  • 联系我们
  • 电话:13714778017
  • 周一至周六:9:00-:18:00
  • 在线客服:

天天IC网由深圳市四方好讯科技有限公司独家运营

天天IC网 ( www.ttic.cc ) 版权所有©2014-2023 粤ICP备15059004号

因腾讯功能限制,可能无法唤起QQ临时会话,(点此复制QQ,添加好友),建议您使用TT在线询价。

继续唤起QQ 打开TT询价