EV4026-J-00A
Universal Input, 7W
Primary-side-control with Active PFC Offline
WLED Driver Evaluation Board For A19 Bulb
EV4026-J-00A Rev.1.3 www.MonolithicPower.com 1
9/9/2013 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2013 MPS. All Rights Reserved.
DESCRIPTION
The EV4026-J-00A Evaluation Board is
designed to demonstrate the capabilities of
MP4026. The MP4026 is a primary-side-control
offline LED lighting controller which can achieve
high power factor and accurate LED current for
an isolated lighting application in a single stage
converter. It works in boundary conduction
mode for reducing the MOSFET and Diode
switching losses.
The EV4026-J-00A is typically designed for
driving an isolated 7W A19 LED bulb with
20V
TYP
, 350mA LED load at universal input
(90V~265VAC, 50/60Hz).
The EV4026-J-00A has high performances in
efficiency, line/load regulation and meets
IEC61547 surges, IEC61000-3-2 Class C
harmonics and EN55015 conducted EMI. It has
multi-protection function as over-voltage
protection, short-circuit protection, primary-side
OCP, etc.
ELECTRICAL SPECIFICATION
FEATURES
Small IC package: SOT23-6
Real current control without secondary-
feedback circuit
Good line/load regulation
High power factor>0.9 over universal input
voltage
Boundary conduction mode improves
efficiency
Input UVLO
Primary-side over current protection
Over-voltage protection
Short-circuit protection
Over-temperature protection
Fit inside A19 bulb enclosure
APPLICATIONS
Solid State Lighting
Industrial & Commercial Lighting
Residential Lighting
All MPS parts are lead-free and adhere to the RoHS directive. For MPS
green status, please visit MPS website under Quality Assurance. “MPS” and
“The Future of Analog IC Technology”, are Registered Trademarks of
Monolithic Power Systems, Inc.
Warning: Although this board is designed to satisfy safety
requirements, the engineering prototype has not been
agency approved. Therefore, all testing should be performed
using an isolation transformer to provide the AC input to the
prototype board.