1 of 10
© 2014 TE Connectivity family of companies
All Rights Reserved
| Indicates Change
*Trademark. TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service, visit our website at www.te.com
PRODUCT INFORMATION 1-800-522-6752
108-2375
24 NOV 14 Rev C
STRADA Mesa* High Speed Mezzanine Press-Fit Differential
Connector System
1. SCOPE
1.1. Content
This specification covers performance, tests and quality requirements for the STRADA Mesa* High
Speed Mezzanine Press-Fit Differential Connector System which provides for interconnection of
parallel printed wiring boards. These connectors are available with contact configurations for high-
speed differential pairs, high-density, single-ended signals, or power applications.
1.2. Qualification
When tests are performed on the subject product line, procedures specified in Figure 1 shall be used.
All inspections shall be performed using the applicable inspection plan and product drawing.
1.3 Qualification Test Results
Successful qualification testing on the subject product line was completed on 07Aug2012.
The Qualification Test Report number for this testing is 501-134006
2. APPLICABLE DOCUMENTS
The following documents form a part of this specification to the extent specified herein. Unless
otherwise specified, the latest edition of the document applies. In the event of conflict between the
requirements of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirements of this specification and the referenced documents,
this specification shall take precedence.
2.1. TE Connectivity (TE) Documents
● 114-13249: Application Specification (STRADA Mesa* Mezzanine Printed Circuit (PC) Board
Connectors)
● 501-134006: Qualification Test Report (STRADA Mesa* High Speed Mezzanine Press-Fit
Differential Connector System)
2.2. Industry Documents
● EIA-364: Electrical Connector/Socket Test Procedures Including Environmental Classifications
● Telcordia GR-1217 (Central Office) Generic Requirements for Separable Electrical Connectors
Used in Telecommunications Hardware (Issue 2 - December 2008)
2.3. Reference Documents
● 108-2385: Design Objectives (EON Compliant Pin For 0.34 mm Diameter Finished Plated Thru
Holes)
● 109-197: Test Specification (TE Test Specifications vs EIA and IEC Test Methods)
