Product
Specification
11 Mar 11 Rev
Crimping Extruded Ring Terminals
©2011 Tyco Electronics Corporation,
a TE Connectivity Ltd. Company
All Rights Reserved
| Indicates Change
*Trademark
For latest revision, visit out website at www.te.com/documents
For Regional Customer service, visit our website at www.te.com
1 of 1
TE logo is a trademark. Other products, logos, and company names might be trademarks of their respective owners. LOC B
1. SCOPE
This specification covers the crimp requirements for extruded ring terminals.
2. CRIMP REQUIREMENTS
2.1. Figure 1 illustrates the various features defined in the following paragraphs.
Figure 1
2.2. Tab on back end of terminals shall be .020 maximum.
2.3. Bellmouth at back of wire barrel shall be .005 to .030.
2.4. Wire shall lay flat and must extend through wire barrel with no more than 3/64 inch maximum overhang.
2.5. Crimp heights and crimp width of the wire barrel and crimp width of the insulation barrel are shown in
the following table:
Wire Barrel
Insulation
Barrel
TE PN
Wire Size
Crimp
Height ±
.002
Crimp Width Crimp Width
18 .056
40894
20 .053
.110 “F” .140 “F”
Table 1
