Product
Specification
108-1228
11Mar11 Rev F
Connector, AMPLIMITE*, Shielded, .050 Series
1. SCOPE
1.1. Content
This specification covers perform ance, tests and quality requirements for AMPLIMITE* .050 series
product. This product consists of printed circuit board m ounted and cable applied plug and receptacle
connectors, excluding S-Bus, ACTION PIN* connectors and product intended for term ination to .025
inch centerline ribbon cable and surface m ount product.
1.2. Qualification
W hen tests are perform ed on subject product line, procedures specified in Figure 1 shall be used. All
inspections shall be perform ed using the applicable inspection plan and product drawing.
2. APPLICABLE DOCUM ENTS
The following TE Connectivity (TE) docum ents form a part of this specification to the extent specified
herein. Unless otherwise specified, the latest edition of the docum ent applies. In the event of conflict
between the requirements of this specification and the product drawing, the product drawing shall take
precedence. In the event of conflict between the requirements of this specification and the referenced
documents, this specification shall take precedence.
! 109-1: Test Specification (General Requirem ents for Test Specifications)
! 109 Series: Test Specifications as indicated in Figure 1
! 114-40029: Application Specification (AMPLIMITE* .050 Series Insulation Displacem ent and
Printed Circuit Board Connectors)
! 501-155: Qualification Test Report (Connector, AMPLIMITE*, Shielded, .050)
3. REQUIREM ENTS
3.1. Design and Construction
Product shall be of the design, construction and physical dimensions specified on the applicable product
drawing.
3.2. Materials
Materials used in the construction of this product shall be as specified on the applicable product
drawing.
3.3. Ratings
! Voltage: 30 volts AC per UL and CSA
! Current: Signal application only, 1 am pere m axim um at 50% energized, See Figure 2.
! Tem perature: -55 to 105°C
©2011 Tyco Electronics Corporation,
a TE Connectivity Ltd. Company
All Rights Reserved
| Indicates change
*Trademark
For latest revision, visit our website at www.te.com/documents.
For Regional Customer Service, visit our website at www.te.com
1 of 7
TE logo is a trademark. Other products, logos, and company names might be trademarks of their respective owners. LOC B
